(1) Where bleachers are provided in tents, they shall be designed in conformance with Articles 3.3.2.8., 3.3.2.10. and Subsection 4.1.5.
Related (referenced by this article)
-
(1) Steps provided in aisles of bleachers of the telescopic type shall, (a) have risers not more than 250 mm high, and (b) have treads with a run not less than 280 mm. (2) If the vertical distance between seating platforms in bleachers is more than 280 mm, an intermediate step shall be provided the full width of the aisle and proportioned to provide two equal risers between platforms. (3) If the vertical distance between seating platforms in bleachers is more than 450 mm, two intermediate steps shall be provided the full width of the aisle so that there are three equal risers between platforms. (4) If the passageway between rows of seats is not a closed deck, footboards shall be provided so that, (a) the total width of the footboards shall be not less than three-quarters of the centre-to-centre spacing between rows of seats, and (b) the spacing between footboard members shall be not more than 25 mm. (5) Openings above footboards and below the seats in rows of bleachers shall be of a size that will prevent the passage of a sphere having a diameter more than 100 mm.
-
(1) Except as required by Sentences (2) to (4) for bleacher seats, guards shall be installed in outdoor and indoor places of assembly with fixed seats so that, (a) at the fascia of every box, balcony or gallery where the seats extend to the edge, the height of guards is not less than, (i) 760 mm in front of the seats, and (ii) 920 mm if located at the end of aisles or at the foot of steps, (b) the height of guards along every cross aisle other than those adjacent to the fascia of every box, balcony or gallery is not less than 660 mm, except that guards need not be provided if the backs of the seats along the front side of the aisle are not less than 600 mm above the floor of the aisle, and (c) where the seating is arranged in successive tiers and the height of rise between platforms is more than 450 mm, the height of guards is not less than 660 mm along the entire row of seats at the edge of the platform. (2) The backs and ends of bleacher seats more than 1 200 mm above the ground or floor that are not adjacent to a wall shall be protected with a guard, (a) not less than 1 070 mm high above an adjacent aisle surface or foot rest, and (b) not less than 920 mm high above the centre of an adjacent seat board. (3) If the front of a bleacher is more than 600 mm above the ground or floor, it shall be protected with a guard not less than 840 mm high above the front foot rest. (4) Openings through any guard that is required by Sentences (2) and (3) shall be of a size that will prevent the passage of a sphere having a diameter more than 300 mm.
-
4.1.5
- 4.1.5.1 — Loads Due to Use of Floors and Roofs
- 4.1.5.2 — Uses Not Stipulated
- 4.1.5.3 — Full and Partial Loading
- 4.1.5.4 — Loads for Occupancy Served
- 4.1.5.5 — Loads on Exterior Areas
- 4.1.5.6 — Loads for Dining Areas
- 4.1.5.7 — More Than One Occupancy
- 4.1.5.8 — Variation with Tributary Area
- 4.1.5.9 — Concentrated Loads
- 4.1.5.10 — Sway Forces in Assembly Occupancies
- 4.1.5.11 — Crane-Supporting Structures and Impact of Machinery and Equipment
- 4.1.5.12 — Bleachers
- 4.1.5.13 — Helicopter Landing Areas
- 4.1.5.14 — Loads on Guards and Handrails
- 4.1.5.15 — Loads on Vehicle Guardrails
- 4.1.5.16 — Loads on Walls Acting As Guards
- 4.1.5.17 — Firewalls